--- ## AUDIO - ⚠️ *"Your DCP has 6 audio channels, rather than 8 or 16. This may cause some distributors to raise QC errors when they check your DCP. To avoid this, set the DCP audio channels to 8 or 16."* - [ ] Ignore if you do not have [[DCP Audio - HI (Hearing Impaired)\|HI]] or [[DCP Audio - VI (Visually Impaired)\|VI]] accessibility tracks. --- - ⚠️ *"Your audio level is very high (on Channel '#'). You should reduce the gain of your audio content."* - ⚠️ This may only appear if you have analyzed each and every channel of audio, individually. - See [[DCP Audio Mix - Recommended Specs]] --- ## BIT-RATE - ⚠️ *"A few projectors have problems playing back very high bit-rate DCPs. It is a good idea to drop the video bit rate down to about 200Mbit/s; this is unlikely to have any visible effect on the image."* --- ## MARKERS - ⚠️ *"[[DCP Format - SMPTE\|SMPTE DCPs]] with the type [[DCP Content Type - FTR (Feature)\|FTR]] (feature) should have markers for the first frame of end credits ([[DCP Marker FFEC - First Frame of End Credits\|FFEC]]) and the first frame of moving credits ([[DCP Marker FFMC - First Frame of Moving (Scrolling) Credits\|FFMC]]). You should add these markers using the '[[DCP Markers\|Markers]]' button in the "DCP" tab."* - [ ] Add Markers for [[DCP Marker FFEC - First Frame of End Credits\|FFEC]] and [[DCP Marker FFMC - First Frame of Moving (Scrolling) Credits\|FFMC]] --- ## SUBTITLES - ⚠️ *"It is advisable to put your [[Subtitle, first card\|first subtitle]] at least 4 seconds after the start of the DCP to make sure it is seen."* --- - ⚠️ *"At least one of your subtitles starts less than 2 frames after the previous one. It is advisable to make the gap between subtitles at least 2 frames."* --- - ⚠️ *"At least one of your subtitles lasts less than 15 frames. It is advisable to make each subtitle at least 15 frames long."* ---